先試後買

A. The Session Border Controller will originate a 403 response when bandwidth allocated to a realm has been exhausted.

B. By default, the Session Border Controller will recurse on the 6xx messages.

C. The Session Border Controller will originate a 503 when there are no steering pool ports available.

D. The Session Border Controller can transmit a different SIP response code than it received.

E. The Session Border Controller cannot originate 3xx class redirect responses.

A. Navigate to the phy-interface configuration element and run the remove-hip-ip <IP address> command.

B. Navigate to the phy-interface configurationelement and run the remove-telnet-ip <IP address> command.

C. Navigate to the network-interface configuration element and run the remove-hip-ip <IP address> command.

D. Navigate to the network-interface configuration element and run the remove-telnet-ip
< IP address> command.

E. Navigate to the network-interface configuration element and run the delete-hip-ip <IP address> command.

A. Navigate to the policy-attribute configuration element and configure the to-address parameter to match the Request-URI value.

B. Navigate to the local-policy configuration element and configure the destination-address parameter to match the Request-URI value.

C. Navigate to the local-policy configuration element and configure the from-address parameter to match the Request-URI value.

D. Navigate to the policy-attribute configuration element and configure the from-address parameter to match the Request-URI value.

E. Navigate to the local-policy configuration element and configure the to-address parameter to match the Request-URI value.

A. Navigate to the sip-config configuration element and set the dialog-transparency parameter to disabled.

B. Navigate to the sip-config configuration element and set the dialog-transparency parameter to enabled.

C. Navigate to the sip-config configuration element and set the call-id-transparency parameter to disabled.

D. Navigate to the sip-interface configuration element and set the dialog-transparency parameter to disabled.

E. Navigate to the sip-config configuration element and set the dialog-mapping parameter to disabled.

A. they replace typical edge routers and firewalls in order to provide a unified network border forsignaling and media control

B. they are based on the Windows operating system

C. they are session-aware devices that enable control of end-to-end interactive communications across IP network borders

D. they provide routing functions for IP, TCP, and SMTPusing application parameters

E. they provide signaling proxy functions for SIP, H.323, and MGCP, which includes access control, signaling constraints, and topology hiding

A. 13

B. 0

C. 157

D. 161

E. 4

A. The default community stringsare public and private.

B. There are no default community strings.

C. Only one trap receiver can be configured.

D. Community strings are in passive mode.

E. The default community strings are acme and packet.