問題1
The opening meeting should happen in the:
Response:
The opening meeting should happen in the:
Response:
正確答案: B
問題2
What is the total tolerance of a blueprint dimension that reads 3" .002"?
Response:
What is the total tolerance of a blueprint dimension that reads 3" .002"?
Response:
正確答案: A
問題3
A triangle has two sides adjacent to the 90 angle that measure 6 mm and 20 mm. The length of the hypotenuse is Response:
A triangle has two sides adjacent to the 90 angle that measure 6 mm and 20 mm. The length of the hypotenuse is Response:
正確答案: C
問題4
The need for gage blocks increases when precision increases, length of part increases, and which of the following?
Response:
The need for gage blocks increases when precision increases, length of part increases, and which of the following?
Response:
正確答案: C
問題5
How many significant digits are in the number 0.046?
Response:
How many significant digits are in the number 0.046?
Response:
正確答案: C
問題6
You are performing a Gage R&R study using electronic micrometers. The display is X.XXXX and the last digit is either a zero or a five. You read the manual that comes with the gage and it indicates that it is accurate to .00002".
Assuming that the tool is sufficiently accurate, how should you perform your study?
Response:
You are performing a Gage R&R study using electronic micrometers. The display is X.XXXX and the last digit is either a zero or a five. You read the manual that comes with the gage and it indicates that it is accurate to .00002".
Assuming that the tool is sufficiently accurate, how should you perform your study?
Response:
正確答案: B
問題7
Which of the combinations of hardness indenter positioning and depth upon indentation are proper?
Response:
Which of the combinations of hardness indenter positioning and depth upon indentation are proper?
Response:
正確答案: D
問題8
Which of the following statements is false about the ring gage:
Response:
Which of the following statements is false about the ring gage:
Response:
正確答案: B
問題9
The task is to measure hole to hole in a vertical pattern. The holes are set at 90 degrees to each other. Which equipment of the following is a good choice?
Response:
The task is to measure hole to hole in a vertical pattern. The holes are set at 90 degrees to each other. Which equipment of the following is a good choice?
Response:
正確答案: B
問題10
Which of the following is a benefit of radiographic inspection?
Response:
Which of the following is a benefit of radiographic inspection?
Response:
正確答案: A
問題11
The plot of the percent of lots expected to be accepted versus the quality of submitted lots is which of the following?
Response:
The plot of the percent of lots expected to be accepted versus the quality of submitted lots is which of the following?
Response:
正確答案: D