先試後買

A. 15%

B. 50%

C. 20%

D. 10%

A. 700 and 1,500

B. 7,000 and 15,000

C. 15,000 and 25,000

D. 1,500 and 7,000

A. The POS Hub provides a port for one 24-volt cash drawer.

B. The POS Hub provides ports for one 12-volt cash drawer and one 24-volt cash drawer.

C. The POS Hub provides a port for one 12-volt cash drawer.

D. The POS Hub provides ports for two 24-volt cash drawers.

A. It is possible to implement the POS Hub only if their current kiosks were originally ordered with the optional
PCMCIA slot.

B. It is not possible to implement the POS Hub with their current AnyPlace Kiosk models.

C. It is possible to implement the POS Hub only if they are running Windows Embedded for Point of Service (WEPOS).

D. The POS Hub is fully compatible with their current AnyPlace Kiosk models.

A. press Ctrl + u after the system has powered on

B. access the Start menu and select IBM Touch Screen Configuration after the system has powered on

C. select the utility from the menu of power on utilities

D. tap the touchscreen twice as the system is powering on

A. install an additional memory module and enable dual-channel memory through the Utilities menu

B. verify that the correct system board was ordered to support dual-channel memory

C. verify that the maximum amount of memory has been installed

D. install two memory modules that are matched by manufacturer, speed, and size

A. a pair of glass panels, each having a thin metallic electrically conductive and resistive layer separated by a thin
space

B. a printed circuit board frame around the perimeter of the display; on two sides there are closely spaced LEDs, and
on the opposing two sides there are matching phototransistors

C. a glass panel with a conductive coating on top and a polyester top sheet with a conductive coating on the bottom

D. a glass panel where the sensor has a conductive coating on the front surface with wires connected to each corner; a
small voltage is applied to each of these four corners